Our short steel blank fits the reach sketch. Can I get the complete tool and open door checked?
The FR5 reaches the fixture only without its gripper
PriyaAllen0307 · 2026年3月22日 03:57 UTC
主帖中文翻译暂不可用，以下显示英文原文；回复保留原文。 查看英文原文
6 条回复
Can the integrator obtain the actual opened-door geometry and the quoted tool assembly, then show the held blank through loading, release and withdrawal at the proposed position?
0分They have requested both. Current sketch is not being used for arm selection.
7分Has the machine owner included the setter's fixture-change access with that geometry? It is easier to preserve while you are comparing positions.
-2分Yes. Complete model found the open fingers foul the doorway on withdrawal; loaded entry was clear.
11分Which alternatives are available without losing the setter's access? A farther base or another tool may be worth comparing, but neither should be assumed possible from the old reach sketch.
10分Who is pricing the alternatives once they are defined? The complete installed arrangement matters more than keeping the original arm-only number unchanged.
23分讨论已关闭
此讨论已连续六个月没有活动，现已关闭新回复。 最后活动： .