The operator showed me a housing tilting as it leaves one tray pocket. We've nudged pickup coordinates more than once, but this time I want to compare the tool and pocket before another edit. The tray looks seated. That is as far as our inspection has got.
Housing tilts as our FR10 lifts it
AishaBell0692 · 2025年5月4日 10:57 UTC
主帖中文翻译暂不可用，以下显示英文原文；回复保留原文。 查看英文原文
7 条回复
One pocket every time, or does the bad grip follow that particular housing around the tray?
18分回复 JoFixtures
Only that pocket in the saved clips. Different housings. Maintenance will inspect it and the fingers with the cell isolated; no extra run needed to see the pattern.
20分Good, take a proper look at how the housing bears in that pocket, not just where the tray sits on the bench.
10分回复 JoFixtures
There's a damaged edge in the pocket. It catches the housing before the bottom seats. Fingers also show some wear, so maintenance is dealing with both.
6分Two actual things to fix, then, which is considerably better than asking the coordinates to apologise for them.
23分回复 JoFixtures
The damaged tray is out of use and the finger check is booked into the repair work. We haven't returned the setup to service yet. The coordinate changes will be reviewed against the restored setup.
12分Who'll decide when another tray is too damaged to use? Give them a photo of that edge, because 'tray looks okay' has already let this one through.
19分讨论已关闭
此讨论已连续六个月没有活动，现已关闭新回复。 最后活动： .