The loose access panel seals against the proposed vacuum tool, but in the supplier's bench video its free edge droops below the fixture lip before release. Our panels arrive stacked, so I have two concerns: getting one sheet, and placing it without someone guiding the edge by hand.
What should our FR5 panel trial show at the receiving fixture?
MayaAli0214 · 2026年2月9日 14:54 UTC
主帖中文翻译暂不可用，以下显示英文原文；回复保留原文。 查看英文原文
13 条回复
回复 MayaAli0214
Ask them to represent the receiving fixture and the panel support through placement, including tool withdrawal. If the bench test needs a hand under that edge, it has not demonstrated your proposed transfer.
16分There is a hand in the clip, briefly. I had thought it was just steadying the fixture, but it is supporting the panel corner. I've asked them to explain that step.
4分回复 MayaAli0214
Was somebody also separating each panel before the clip starts, Maya, or did you see it leave an actual stack?
14分回复 MayaAli0214
I would ask for the untrimmed recording before paying for another trial. You may learn a lot from what happens just outside the chosen start and end points.
5分回复 MeiAdams0168
Full recording shows a person handing over one panel. No stack pickup. The supplier agrees the video only demonstrates the seal and proposes a supported tool for the fuller trial.
21分回复 MayaAli0214
A supported tool could help, but find out whether the support can leave the fixture without lifting or dragging the panel. I mean leave after placement, not just fit in while carrying it.
15分Sarah, yes. I'd want the proposed support and the fixture drawn together before they make it. The lip already causing trouble is likely to matter during withdrawal too.
25分回复 MayaAli0214
And where does a suspected pair go, because I would not want that decision left to whoever happens to be standing nearest?
8分We have asked for an identified stopped-recovery position for uncertain pickups. The proposed single-sheet check has not been tested with our stacked panels yet, so that remains part of the trial.
15分回复 MayaAli0214
Thank you for checking the full recording. That little hand was doing a surprisingly large part of the job. Did they charge for the supported-tool proposal?
10分回复 MeiAdams0168
No charge for this proposal, Mei. Its section shows a support rail colliding with the fixture lip on withdrawal, which our fixture designer spotted. They are revising it before making hardware.
8分回复 MayaAli0214
Useful catch. I would rather argue over that section than watch somebody discover it with a panel hanging from the tool.
19分回复 MayaAli0214
Has the revision changed the fixture or the tool, Maya? Either may be reasonable, but it changes who supplies the work in your quote.
19分讨论已关闭
此讨论已连续六个月没有活动，现已关闭新回复。 最后活动： .