简体中文界面。帖子、指南及政策正文保留原文；未对原文作自动翻译。
RickShift · 2026年1月16日 10:41 UTC
Can the operator show whether the housing is fully seated before the first contact, using an identified sample?
18分It sits flat before contact. One finger then pushes it across before the second touches.
7分Compare the intended contact positions. First touch alone doesn't tell you which finger is wrong.
17分Keep the finger pair and the housing together for that comparison. We once replaced the obvious worn bit, then found its supposedly good partner had also been changed during an earlier repair. Not saying yours has, just don't make one nice-looking side the reference without checking it.
9分Who owns the accumulated pickup changes while maintenance checks the hardware? The most recent job may be compensating for whatever they're about to remove.
13分Integrator owns the saved versions. Maintenance found different contact heights on the fitted pair; tooling is checking their references.
12分Are those heights different from the intended pair, or just different from each other?
14分Different from the intended pair. One finger belongs to another housing setup. Metal references confirmed, not judged from colour.
8分Then the drawer deserves a look as well. Once the right pair goes back, someone can recreate this by taking the same near-match next changeover. Our repair lasted exactly as long as the tidy spares label.
9分Useful identification. Keep the job comparison and handling verification with the replacement work, so the shift doesn't hear matched pair fitted as permission to use the old compensation blindly.
3分Has stores separated the two setups yet?
18分此讨论已连续六个月没有活动，现已关闭新回复。 最后活动： .