Our bracket sheet says angle checked in fixture, then straightened. I need the released result for our FR5 plan. Where should I look?
Which bracket angle belongs on our FR5 planning sheet?
TobyArcher0405 · 2025年8月10日 23:35 UTC
主帖中文翻译暂不可用，以下显示英文原文；回复保留原文。 查看英文原文
11 条回复
Start with whoever accepted the finished brackets. They may have a separate inspection sheet. I helped assemble a handover where the production tick only meant the part was ready for the next operation, which nobody had written beside the tick.
11分Quality has a final sheet. It is after straightening, with no earlier angle listed.
9分Then ask the fabricator how they decided a bracket needed straightening. There might be a gauge or a comparison sample that never made it into the folder. I would want that explained to the fixture designer.
15分Don't buy another clamp on the strength of that sheet. Can you get someone to show you the old check? Easier than arguing over what a tick meant.
3分回复 MeiAdams0168
I can ask. The old fixture is still stored here.
8分Fabricator showed me a separate angle gauge. They check after release, then send some brackets for correction. Nobody kept those first readings.
20分There we go, a missing operation. Not a mysterious robot requirement. Did they show where the bracket rests for that check?
15分Our check bench went missing from a layout because it looked like spare furniture. Give the planner its dimensions too.
10分Keep that check in the estimate until a trial shows what the new process produces after release
14分Toby, you can still use the final sheet to describe what was accepted. Just do not ask it to explain the earlier condition. The missing readings will need new evidence if they matter to the fixture proposal.
19分回复 MeiAdams0168
Yes, Mei. Gauge sits on the base face. I've added its support sketch and kept the check bench.
6分讨论已关闭
此讨论已连续六个月没有活动，现已关闭新回复。 最后活动： .