The proposed vacuum tool holds one stainless cover panel in the bench report. Our feed is a stack, and the recording starts with one panel already lifted clear by hand. What should the supplier demonstrate to explain separation and support without asking us to infer both from a maintained seal?
our ur5e panel test begins after someone separates the stack
OwenAli0225 · 2025年12月2日 02:07 UTC
主帖中文翻译暂不可用，以下显示英文原文；回复保留原文。 查看英文原文
7 条回复
回复 OwenAli0225
Ask for your received stack condition through single-panel confirmation, transfer and release into the nest.
22分Our stack samples are there. Supplier says manual separation was only for the bench test, but has not proposed how the installed arrangement would do it.
24分回复 OwenAli0225
Does their quotation include separation, or leave that preparation with your staff?
9分It says panel transfer, which is why I asked. They are clarifying the incoming condition and separation scope before revising the trial request.
12分回复 OwenAli0225
Include how one panel is confirmed. Separation and knowing it succeeded are both needed.
13分Included, along with the panel condition after release. I also asked them to address the unsupported far corner visible in the existing single-panel view. No revised proposal yet.
24分回复 OwenAli0225
Did the supplier return a defined stack-handling proposal, Owen, or is that scope still open?
14分讨论已关闭
此讨论已连续六个月没有活动，现已关闭新回复。 最后活动： .