Our FR10 tray-unloading grip is becoming less square on rigid spacer blocks, and we keep compensating at the pickup points. The tray looks unchanged, but I have no measurements behind that impression. Where should maintenance look before we add another correction?
Cannot justify another FR10 spacer pickup nudge
HazelBennett0745 · 2026年7月6日 08:14 UTC
主帖中文翻译暂不可用，以下显示英文原文；回复保留原文。 查看英文原文
5 条回复
Compare the block's seating before grip with its held position. Preserve the point versions for maintenance.
24分回复 PriyaAli0220
We saved the versions. Maintenance found one spacer rocking before closure and has retained it alongside a block that sits flat. No conclusion about the arm from that pair.
5分Does the same spacer rock on the specified inspection support, or only in this tray pocket?
13分回复 PriyaAli0220
It rocks on the inspection support too. Inspection found a raised edge outside the part requirement; that block is segregated. We still need the remaining stock checked and the accumulated point changes reviewed, so this isn't a claim that every poor grip had one cause.
10分Keep the rejected block identified with that finding; verify the approved setup using conforming stock before closing the handling issue.
12分