The offline FR10 welding sketch reaches the bracket's inside corner with a line representing the torch, while the actual clamp and torch body look crowded; what should the integrator model before this becomes an approved layout?
our FR10 torch is a line through a real clamp
CallumAli0186 · 2025年10月7日 06:35 UTC
主帖中文翻译暂不可用，以下显示英文原文；回复保留原文。 查看英文原文
7 条回复
Use the full torch assembly and clamps in their actual welding positions.
5分Include the approach and exit too, with the welding specialist's required orientation and access conditions. A body that fits at one point can still have no useful route into that corner.
13分Hana, would you include the cable arrangement at this stage?
12分回复 KaiBrown0889
Yes, the proposed routing and its constraints, even if some details remain provisional. I would not approve access from a torch body floating alone while the cable is left for someone else to discover.
2分Full assembly is now in the study; one clamp obstructs the required orientation, so the fixture designer and welding specialist are comparing alternatives without changing the physical setup yet.
18分Is the proposed clamp change assessed for its holding job as well?
10分回复 KaiBrown0889
That matters, Callum. Moving the obstruction is only useful if the revised fixture still locates and restrains the bracket as required; ask for the welding access and fixture review to stay linked.
10分讨论已关闭
此讨论已连续六个月没有活动，现已关闭新回复。 最后活动： .