简体中文界面。帖子、指南及政策正文保留原文；未对原文作自动翻译。
Rowan_Bowen · 2026年2月12日 20:56 UTC
Not as a paired movement value without resolving the measurement conditions. Put the actual supports and drawing requirement beside each result. The corrected pass also follows an operation that the first reading did not.
12分Quality confirms the first check used the welding fixture as support. Final check used the inspection fixture after correction. Neither sheet records the first freely released condition on the inspection fixture.
4分Then that missing condition stays missing. You can retain both historical observations without subtracting them. A fresh identified set needs the incoming fit-up, intended location, first released check and any correction tied together.
14分Removed the movement figure from the proposal. Fabrication and quality agreed the new observation sheet, including the correction operator's entry. Historical pair retained with the reason it cannot support that calculation.
0分Thank you for keeping the original pair. It explains why the estimate changed, and it may still help the people planning the new checks.
20分此讨论已连续六个月没有活动，现已关闭新回复。 最后活动： .