Our FR10 housing leans before the fingers even close

Retained housing sits flat. Two new ones catch near the same rear corner.

Have quality compare that housing edge with the drawing, and tooling check what it is touching in the fixture; the corner may be exposing a part difference or an unwanted fixture contact.

Did the new housings arrive under the same part reference?

Same delivery reference. Quality has kept those two and a seated example from the new delivery.

Same reference on a box doesn't settle the moulded shape. Has anyone checked the actual rear edge yet?

Beth, that's already with quality. Ada, keep the original point set with this comparison as well as the corrections; someone will need to untangle them when the seating is right.

Quality found excess material at that edge on the two awkward housings. Fixture contacts match their drawing.

Let quality decide the stock disposition against the requirement; do not teach the pickup around an edge they have already found suspect.

Is the seated new housing acceptable, or merely easier to load?

And where are the suspect ones now? Our useful samples have a habit of joining the next tray.

Beth, quality accepted the seated example. Louis, suspect delivery is held and marked, with the samples retained separately.

Reviewed original setup passed the full transfer with accepted retained and new examples. The three compensations aren't being carried forward.

Thank you, Anna. Supplier has the edge findings; replacement stock hasn't arrived, so the delivery issue remains open.

Useful split result. Make sure the incoming check can find that edge issue again; the next good-looking box will still have the same reference on it.