简体中文界面。帖子、指南及政策正文保留原文；未对原文作自动翻译。
AnnaAli0242 · 2026年2月21日 08:52 UTC
Does the spacer move within the fingers, or do the fingers and spacer move together when it turns? The same silhouette can hide two different faults.
19分Within the fingers. Whole tool doesn't visibly turn. Clip loses the far tray edge just before it happens.
23分We found a guide touching the carried part before it reached the intended pocket. Keep the actual tray and spacer for maintenance, but don't label yours the same fault without seeing that contact.
14分Our loading view hid a rear guide too. Can maintenance inspect the far edge from a better view with the setup stopped? No reason to keep guessing from the same cropped clip.
15分Stopped inspection found a raised tray divider near the hidden edge. Retained spacer has a mark there. Maintenance comparing it with the intended tray drawing.
18分Our good pickup check still left other pockets and release to assess. If that divider is repaired, keep those cases in the return comparison.
-3分Is the divider meant to be that high on this tray version, Anna?
12分No. Drawing shows it below that contact path. Maintenance found its mounting loose and the divider lifted on one side.
8分Give controls that physical finding with the saved pickup edits. They should review the accumulated changes before returning the corrected tray to the job.
23分Done. Tray held for repair, controls reviewing edits. No more pickup nudges offered as a result.
14分Who will check that divider mounting at handover once it is repaired? Use the actual loose area in the maintenance note while it is still visible.
7分此讨论已连续六个月没有活动，现已关闭新回复。 最后活动： .