I'm reviewing an FR5 bracket proposal that copies the old fixture but omits its straightening bench. Nobody explained why.
AL
Do you know whether the old brackets needed that bench routinely, or only for occasional rework?
23分简体中文界面。帖子、指南及政策正文保留原文；未对原文作自动翻译。
Mystery straightening step missing from the new layout
AnikaBell0682 · 2025年5月19日 20:40 UTC
10 条回复
回复 AlexCell
No. Records show clamped checks, then some released failures. Straightening has no separate count.
20分AL
Who signed off the assumption that the bench can disappear? That's the decision you need reopened while the old process is untangled
25分Had a layout lose a manual check because nobody put it in the cycle list. The operator still did it, just with nowhere sensible to stand. Anika, is the person who used this bench in your review?
-6分回复 BrunoAli0191
Not yet. I've asked the former setter to join quality and the fixture designer.
13分Setter says it was frequent, but can't identify which recorded parts were corrected. We need that uncertainty visible.
6分AL
Can quality define a comparison that measures the released bracket before any correction, alongside the incoming fit-up? That would answer what the old sheets keep skipping
25分Do any untouched retained brackets exist? A look at those might help the designer frame the comparison, even if the old paperwork cannot give you a reliable rate.
10分A few tagged samples remain. Quality will review them; layout approval paused until the process decision is clearer.
8分Give the person drawing the layout that pause explicitly. Otherwise they'll keep optimising the space around a job that still needs deciding.
22分讨论已关闭
此讨论已连续六个月没有活动，现已关闭新回复。 最后活动： .