Our angle-bracket notes look aligned in the fixture and fail the drawing after release. Correction appears before acceptance with little explanation. I need the old fit-up, fixture-location and final checks separated before we specify the new FR5 welding cell. What was actually measured at each stage is still unclear.
Cannot choose FR5 bracket controls from a restrained alignment tick
OmarAllen0317 · 2026年6月22日 14:48 UTC
主帖中文翻译暂不可用，以下显示英文原文；回复保留原文。 查看英文原文
1 条回复
In my review the restrained entry was a fit-up gauge check and final inspection used drawing datums, so subtracting them would have invented a movement; establish your references, drawing revision and support conditions first, then retain the correction as recorded work without assuming its need, amount or suitability for the new cell is proved.
8分