Our hand-loaded spacer blanks protrude differently. The UR5e planning sheet omits loose blank lengths and seating observations.
ur5e blank plan with only exposed-length measurements
ZaraChen1178 · 2025年12月26日 13:09 UTC
主帖中文翻译暂不可用，以下显示英文原文；回复保留原文。 查看英文原文
6 条回复
回复 ZaraChen1178
I would start by keeping each blank's identity through a loose-length measurement and the setter's seated check, using an agreed reference. We once had a very convincing scatter of protrusion figures that combined different blank lengths with two different measuring positions. Nobody had done anything exotic; they had just filled a heading that didn't say enough. Also note the end contacting the stop and any visible burr or preparation difference. Don't retrofit paired values to the old sheet by matching the shortest-looking blank to the shortest reading. New linked observations are much more useful than tidy guesses.
19分The setter and quality will agree the reference. Retained blanks are now individually identified for new paired observations.
8分回复 ZaraChen1178
Are both ends prepared the same way on those retained blanks?
17分No. One end has a visibly different edge finish. We have not established whether it affects seating.
9分回复 ZaraChen1178
Keep which end meets the stop in the observations, then. The setter can investigate the contact with those identified samples. Different appearance is a reason to look, not enough by itself to name the cause.
21分Did the paired comparison separate length variation from seating, Zara? Interested whether the different end finish actually mattered.
25分讨论已关闭
此讨论已连续六个月没有活动，现已关闭新回复。 最后活动： .