简体中文界面。帖子、指南及政策正文保留原文；未对原文作自动翻译。
SaraAllen0287 · 2026年3月9日 22:12 UTC
An operator showed us a part already leaning before the fingers closed, after everyone had blamed the grip, so I would start with when the tilt appears and keep the job edits available beside that observation.
22分We have a clear view of it now: sleeve upright in the pocket, then it tips as the second finger arrives; I have asked maintenance to compare both contact pieces with the assembly drawing.
18分Do those contact pieces have matching identities, Sara, or was one replaced separately?
25分They can have matching names and still sit differently if the mounting is wrong, so include how they are fitted rather than stop at the labels.
6分One was replaced separately, Thomas, and maintenance found a thin backing piece left behind the new contact; it is not in the intended assembly and makes that side arrive early.
12分Give that finding to the integrator with the saved edits, because a job adjusted around the proud contact will not become right merely because the backing piece has gone.
-3分Maintenance restored the specified contact assembly and the integrator has the edit history; the physical correction is finished but the transfer comparison is not, so no claim that the sleeve job is sorted yet.
11分When they compare it, include release into the receiving fixture as well as the now-square pickup, since that is where a leftover compensation could still show up.
9分此讨论已连续六个月没有活动，现已关闭新回复。 最后活动： .