I'm reviewing historical records for our planned preparing robotic welding of gusseted brackets with Universal Robots UR5e and a steel gusseted bracket assembly in a robotic welding project review. The notes describe alignment under restraint but dimensions outside the drawing requirement after release.
I'd like to distinguish incoming fit-up, fixture location and final acceptance before carrying an unexplained correction routine into the new cell; no live welding adjustments are involved.
Compare the specified inspection condition and reference supports with the historical sheets. Do individual measurements identify whether the assembly was restrained or released?
My sheets contain both restrained and released results, with some conditions unlabelled. Although the drawing specifies the dimension, the inspection procedure doesn't clearly define the supports.
Ask quality and the design owner to establish the intended acceptance condition, then group historical results by their documented measurement state to support comparison.
@HenryCarter0960 Same restraint label still doesn't mean comparable. Unknown supports and mixed fixture or process revisions could remain inside those groups.
You're right; I overstated that. Grouping exposes one difference. Keep support conditions, fixture revision and process links visible too, including anything unknown.
Should a fixture revision remain unknown when a colleague remembers a likely version but no record confirms it? We're disagreeing about whether to fill those gaps.
@VictorCarter0968 Keep the revision unconfirmed in the data. A separate note can preserve the recollection as a lead without presenting it as an established fixture reference.
I had a separate bracket job where inferred fixture revisions created an apparent trend. Once the original sheets established the revisions, the trend no longer held.
@JamieAdams0121 The acceptance requirement may apply to the released assembly. A dimension maintained by fixture restraint doesn't establish what that dimension will be once the restraint is removed.
@HenryCarter0960 The drawing owner confirms released inspection on specified reference supports. Quality is putting that condition into the sheet. At least that part won't be guessed.
My review approach is settled: establish the acceptance condition and use measurements with identifiable conditions. I can take that forward while leaving fixture and process changes dependent on specialist assessment.