Our brass-blank sheet only gives exposed length after hand loading. What else distinguishes blank variation from seating?
Which measurements should accompany our FR10 blank stick-out readings?
SarahChen1198 · 2026年2月15日 13:00 UTC
主帖中文翻译暂不可用，以下显示英文原文；回复保留原文。 查看英文原文
5 条回复
Identify each blank and measure its relevant dimensions, including overall length, against the drawing. Inspect the seating end. Pair those with repeated supervised seating observations using the same defined stop and measuring reference, rather than comparing anonymous stick-out numbers.
22分Identities added. Two longer blanks explain their extra exposure. One ordinary-length blank still varies between loads.
12分Keep that particular blank for inspection of its seating end and contact with the defined stop. Include ordinary conforming examples too, so a single awkward end does not become your estimate of normal seating behaviour.
10分Quality found a raised edge on that blank and excluded it. Remaining identified blanks seat consistently with length variation accounted for.
1分That gives the planned loading study a useful manual baseline. Keep the rejected blank's finding separate; this comparison does not by itself establish the automatic-loading arrangement.
7分讨论已关闭
此讨论已连续六个月没有活动，现已关闭新回复。 最后活动： .