I have hand-loaded brass sleeve blanks with different stick-out readings in our FR5 planning sheet, but no matching overall lengths or repeated readings on the same blank; what should quality and the setter compare before anyone calls the spread a robot-position problem?
Which measurements belong beside our FR5 brass-sleeve stick-out readings?
RobinAllen0338 · 2026年2月13日 11:21 UTC
主帖中文翻译暂不可用，以下显示英文原文；回复保留原文。 查看英文原文
4 条回复
Have them agree the measuring reference, identify each blank and measure its overall length and locating-end condition, then compare repeated seating of those same blanks rather than treating every reading as a different part.
19分Setter and quality have agreed one reference and added blank identity, length and end condition to the sheet; repeated loadings keep separate entries under the same blank, and automatic loading remains outside this comparison.
9分Keep the ordinary range of accepted blanks in it too, so the first nicely repeatable example doesn't become the allowance for every sleeve you actually issue.
9分Has the comparison produced any repeated readings yet, Robin? I'd like to hear whether the same blank varies or whether most of the spread follows the different lengths. Could be both, of course.
-2分讨论已关闭
此讨论已连续六个月没有活动，现已关闭新回复。 最后活动： .