I've stopped judging our spacer pickup from the overhead view. Side footage shows the block rotate when the second finger makes contact. The fixture seat looks settled before that, though maintenance hasn't finished comparing it with the drawing.
We've got the fitted fingers identified properly this time, not by their colour. What would you compare next before another point tweak makes the video look nicer?
Our FR10 spacer looks square until the second finger arrives
LinBrooks0792 · 2026年1月11日 06:26 UTC
主帖中文翻译暂不可用，以下显示英文原文；回复保留原文。 查看英文原文
16 条回复
Compare the intended contacts with the actual pair. A matching label doesn't show wear or seating.
13分Include the block's actual dimensions and the contact heights. One finger touching first may be expected; the observed rotation needs comparing with the intended grip.
18分Was the same rotation visible before the latest pickup adjustment? Keep the earlier footage if available.
23分Can you still identify which job version made each clip?
17分And finish the seat comparison. Our sleeve row looked level until we checked its support from another side.
20分Anil and Zara, both clips are linked to saved job versions, and the rotation predates the last adjustment. Will, maintenance is still checking the fixture. Grace, they've got the actual spacer with the fingers, not just my close-up.
-4分The side view is useful. Is the second contact face actually flat against the spacer when it finishes closing, or does it catch an edge? I can't tell you which is right without the tool design, but that difference is worth showing.
7分Who is covering the cell while maintenance and the integrator compare those job versions?
13分Keep the identified pair out of the general spares drawer during this. Otherwise somebody can tidy away the evidence and leave the next shift with two immaculate substitutes.
13分Are replacement contact pieces available as a matched pair, if the inspection finds wear?
14分Harish, the second contact catches on a damaged raised edge. Maintenance confirmed the fixture seat matches the intended arrangement. Elena, the shared work has moved to the existing manual bench; our supervisor has assigned cover rather than leaving it with the same operator twice.
14分That gives tooling something concrete. I wouldn't flatten the damaged edge locally until they've said whether repair or replacement is appropriate for that contact.
10分Agreed. Retain its received condition and ask the toolmaker to compare the damage with the intended contact profile. Correcting the profile must not change where the block is meant to sit.
13分Aaron, a matched replacement pair is available and the toolmaker has identified it against our assembly. Maintenance will fit it under the reviewed replacement work. We kept the damaged pair, Caleb. This time stores gets an actual part reference instead of another bag of blue things.
14分Has the integrator reviewed the accumulated pickup changes against that intended replacement setup?
1分回复 NoahChan1064
Yes, the job comparison is done and the replacement pair is fitted. The controlled pickup check no longer rotates the retained spacer. Release and the remaining sample range still need verification, so the manual cover stays. Thanks, Grace, for asking about contact height rather than just which finger arrived first.
16分讨论已关闭
此讨论已连续六个月没有活动，现已关闭新回复。 最后活动： .