The old gusset-bracket sheet says height good in jig, low on bench. No measured feature named. I can't use that to justify a correction step in our FR5 proposal.
Which bracket height was checked after the clamps came off?
EmmaBennett0724 · 2025年10月3日 10:45 UTC
主帖中文翻译暂不可用，以下显示英文原文；回复保留原文。 查看英文原文
2 条回复
Find the inspector's actual check, if it survives. 'Height' could mean the top edge from the bench or a drawing dimension from a specified datum. And sitting on the bench may not reproduce that datum at all.
17分回复 ElenaAli0253
Found a sketch showing the top edge measured from the bench surface. The drawing uses the mounting face. Quality needs to establish how the bracket was supported before we call those readings comparable.
17分讨论已关闭
此讨论已连续六个月没有活动，现已关闭新回复。 最后活动： .