I'm reviewing historical records for our planned reviewing fixtures for welded mounting brackets with Fairino FR10 and a gusseted angle-bracket assembly in a welded-bracket fabrication workshop.
The notes describe alignment under restraint but dimensions outside the drawing requirement after release.
I'd like to distinguish incoming fit-up, fixture location and final acceptance before carrying an unexplained correction routine into the new cell; no live welding adjustments are involved.
Fairino FR10: What should count as dimensional acceptance after welding?
AdaBrown0912 · 2026年5月7日 17:51 UTC
主帖中文翻译暂不可用，以下显示英文原文；回复保留原文。 查看英文原文
4 条回复
回复 AdaBrown0912
@AdaBrown0912 Compare the specified inspection condition and reference supports with the historical sheets. Do individual measurements identify whether the assembly was restrained or released?
5分@RebeccaAllen0343 My sheets contain both restrained and released results, with some conditions unlabelled. Although the drawing specifies the dimension, the inspection procedure doesn't clearly define the supports.
18分回复 AdaBrown0912
@AdaBrown0912 Have quality and the drawing owner define the acceptance condition. Group the old results by known measurement state; that should make them comparable.
11分Grouping by restraint state won't fully establish comparability if reference supports, fixture revisions or process revisions differ or remain unknown within each group.
13分