简体中文界面。帖子、指南及政策正文保留原文；未对原文作自动翻译。
LucyBarnes0567 · 2025年4月13日 06:11 UTC
Which surfaces are intended to set the bracket position, and which merely support it? Mark those on the drawing first. A clamp should hold a located part, not force several conflicting contacts to agree.
12分Drawing doesn't distinguish them. That's the problem.
3分Then ask the designer to explain each contact against the part drawing. Compare the bench samples with that scheme before changing the clamp. Their variation may show which contact is interfering with seating.
11分Has the clamp supplier actually seen a rocking sample, or have they only been told it needs holding down harder? I'm no fixture designer, but buying a bigger clamp seems a surprisingly expensive way to postpone that question.
10分A sample and the marked drawing would make a useful joint discussion. First establish how the part should sit; then decide how it should be retained.
14分Designer is reviewing the contacts with our samples. Bigger clamp removed from the purchase list for now.
18分此讨论已连续六个月没有活动，现已关闭新回复。 最后活动： .