Our hand-loaded aluminium blanks fall into two protrusion groups. The UR5e loading proposal assumes one stop position, but our sheet has no paired blank-length measurements to explain the split.
Two protrusion groups in our lathe blank samples
JonasBrown0894 · 2025年12月6日 17:05 UTC
主帖中文翻译暂不可用，以下显示英文原文；回复保留原文。 查看英文原文
9 条回复
Measure each loose blank and keep its identity with its seated reading. Two groups alone won't tell you what changed.
13分We have retained the samples, although the earlier seated readings cannot be matched to individual blanks. New paired measurements are being arranged with the setter.
-2分Don't quietly pair them by shortest to shortest. Seen that turn guesses into a very convincing spreadsheet
16分Will the setter also note which end meets the stop, particularly if the two ends are prepared differently?
5分Ravi, yes, ours once had a burr on only one end. Easy to miss from the front.
3分Maya, did the burr change the seating or was it just visible damage?
13分It held those samples off their stop. Not saying Jonas has the same cause.
11分Our paired measurements show two supplied blank lengths; the setter also found one damaged end, which is being kept separate rather than averaged into either group. The automatic-loading proposal remains on hold.
4分Has planning decided whether both lengths genuinely belong in this job, or did the stock arrive mixed?
13分讨论已关闭
此讨论已连续六个月没有活动，现已关闭新回复。 最后活动： .