简体中文界面。帖子、指南及政策正文保留原文；未对原文作自动翻译。

Workshop owner evaluating a first automation purchase

EmmaBell0637

Emma Bell

Australia加入于2025年12月2日56篇帖子

关于

Workshop owner evaluating a first automation purchase. Currently exploring robot comparisons and fixtures. Working around mixed supplier documentation; planning a 12-week trial before making a decision.

Robot comparisonsFixtures

参与的讨论

A small steel assemblies factory: Fairino FR10 welding plan: I don't want to inherit an unexplained correction routine

AmaraCarter1035 · 19 分 · 应用与集成 · 2026年9月3日

20条回复 E

Fairino FR5: defining dimensional control for bracket welding: held straight and finished straight aren't the same check

EmmaBell0637 · 28 分 · 应用与集成 · 2026年8月5日

15条回复 E

A shared fabrication workshop: Handling an aluminum locating sleeve went well. My write-up needs more context.

EmmaBell0637 · 16 分 · 评测与对比 · 2026年8月3日

2条回复 A

A small steel assemblies factory: The fixture holds nominal shape. What happens after release?

AaronAdams0088 · 10 分 · 应用与集成 · 2026年7月25日

10条回复 E

Universal Robots UR5e: Why does our offline retry test accept the wrong result?

EmmaBell0637 · 27 分 · 编程与技术支持 · 2026年7月17日

6条回复 A

The bracket is 'aligned' right up until someone releases it

AnikaBell0682 · 15 分 · 应用与集成 · 2026年7月8日

20条回复 V

What should count as dimensional acceptance after welding? (defining dimensional control for bracket welding)

VictorCarter0968 · 6 分 · 应用与集成 · 2026年5月29日

2条回复 E

A small steel assemblies factory: What should count as dimensional acceptance after welding?

EmmaBell0637 · 13 分 · 应用与集成 · 2026年5月27日

14条回复 E

EmmaBell0637

关于

参与的讨论

A small steel assemblies factory: Fairino FR10 welding plan: I don't want to inherit an unexplained correction routine

Fairino FR5: defining dimensional control for bracket welding: held straight and finished straight aren't the same check

A shared fabrication workshop: Handling an aluminum locating sleeve went well. My write-up needs more context.

A small steel assemblies factory: The fixture holds nominal shape. What happens after release?

Universal Robots UR5e: Why does our offline retry test accept the wrong result?

The bracket is 'aligned' right up until someone releases it

What should count as dimensional acceptance after welding? (defining dimensional control for bracket welding)

A small steel assemblies factory: What should count as dimensional acceptance after welding?

How do I check whether this fixture is overconstrained?

How do I find what our bracket correction actually corrected?

Trim-plate scratch labels without a physical location

Which collection record belongs to our UR5e and tray gripper?

Demonstrator preparation missing from my UR5e review

Which released-bracket reading belongs with our UR5e fixture estimate?

two bracket checks share one handwritten number

Which receipt would show our FR5 left the seller rather than acquired a label?

Can I compare our bracket checks without knowing where they were measured from?

Can I use our old bracket records when the inspection datum is not named?

How can I tell whether logging is freezing our FR5 monitor?

Cannot rank the FR5 spacer demo against a tray somebody filled off camera