I came onto our FR10 unloading job after a finger replacement and found two pickup adjustments in the notes. Both say improved. Housings still sit at a slight angle in the grip on some pickups.
Tray location seems unchanged. Before we book someone to reteach the job, I'd like to understand whether the replacement fingers match what was fitted before. The old set is still here.
Crooked housings after a finger replacement
AishaBell0692 · 2025年8月14日 03:34 UTC
主帖中文翻译暂不可用，以下显示英文原文；回复保留原文。 查看英文原文
14 条回复
What changed on the fingers, Aisha? Same part number isn't much help if one set has been repaired or packed out. I'd have the old and new pairs compared while the equipment is isolated for the inspection.
16分回复 OmarAli0230
Old pair has a shallow relief on one contact face. New pair has flat faces. The supplier description calls both the same set, but our tool drawing shows the relief.
19分That's something the tooling designer can actually answer. Does the relief clear a feature on the housing, or was it added to the old fingers later?
20分回复 OmarAli0230
It clears a moulded rib. Drawing revision D includes it. New fingers came against the same order reference, without a drawing revision on their bag.
16分Send the supplier D, not just the order reference.
19分Our replacement set once matched the stock description and nothing else. Keep the two pairs separately identified until purchasing has sorted out which drawing the supplier used.
13分Supplier used revision B. Purchasing has sent D and requested the correct set. The present job is held. Old fingers were replaced for wear, so they are not a ready fallback.
9分Were the pickup adjustments made before or after the new fingers went on?
15分回复 RobinAli0251
Both afterwards. We have the earlier backup, but I don't want someone simply loading that and calling it fixed when the replacement tool hasn't arrived or been checked.
11分Agreed. Keep the backup for comparison and have the integrator review those edits with the correct physical setup. Two compensations for a wrong contact face may be the last thing the right fingers need.
16分Has the supplier confirmed D this time?
15分Also make the changeover check show that rib clearance. Somebody receiving a shiny new pair shouldn't have to reconstruct this thread to notice the flat face is wrong.
21分回复 OmarAli0230
They confirmed D and supplied the revised fingers. Tooling checked the geometry against the drawing. The loaded transfer trial and program review remain to be done. Omar, we have added the clearance view to the receiving check.
8分Useful progress. Did purchasing change the stock description too? Otherwise the next replacement order can go straight back to B.
19分讨论已关闭
此讨论已连续六个月没有活动，现已关闭新回复。 最后活动： .