Our spacer block looks level in its source fixture, then one end rises as the fingers close. Repeated pickup corrections have not stopped it. I want the contacts checked before another point change.
Our UR5e spacer tilts as the fingers close
JamieBell0643 · 2026年3月28日 15:41 UTC
主帖中文翻译暂不可用，以下显示英文原文；回复保留原文。 查看英文原文
19 条回复
We had mismatched pads do that on sleeves. Have maintenance compare the fitted contact references and their seating with the assembly drawing. Not saying yours is the same fault, but it is a useful physical check before teaching around it.
19分Were either of the contacts replaced or reworked before this started, Jamie?
16分Also check what looks level means. A front view can hide a block sitting on a rear corner. You need the seat and the grip in the same explanation.
6分Use a retained block alongside a current one if you have it, because buying contacts won't answer whether the incoming part changed
7分Pavel, one contact was dressed after damage. Lucy, level is only from the operator's view so far. Dinesh Bennett, we retained the first accepted block.
10分Who accepted that dressed contact for this job? The repair description may matter more than its original part number.
8分And note which job version each pickup correction belongs to, so the integrator can later compare them with whatever physical condition is found.
17分Was the damage on the contact face?
25分Can the person who dressed it show what was removed, or is the shift note just repaired?
10分回复 Ash_Briggs
Ash is right. Matching references would not establish the present shape after somebody has reworked one face. I should have included condition in my first reply.
15分Noah, the references are still useful. I just found a spare from another family in the wrong kit. Jamie needs both identity and the actual repaired shape checked.
21分Please don't let the repair story stop the source-seat check either. It is plausible, but Jamie hasn't yet confirmed the block starts square from another view.
25分Elliot, the contact face was damaged. Beth, the note says dressed smooth with no dimensional check. Ash, I cannot find who accepted it back into this job. Maintenance is comparing it with the drawing.
14分Jamie, has the retained block reached that comparison too, or only the current one?
15分Yes, Dinesh Bennett. Both blocks seat square in the static fixture check from front and rear. Both meet the dressed contact differently from the other side. Maintenance has measured the faces for tooling to assess.
9分Thanks, that narrows the question. Is the repaired contact still in use while tooling decides?
5分For the eventual return check, include release into the tray as well as the square pickup; our sleeve comparison needed both before we closed it.
7分回复 Ash_Briggs
Ash, no, this transfer is paused. The measured contact shape differs from the drawing and tooling has not accepted it. Dinesh Carter, release is included in the requested return check.
7分Who owns getting a serviceable contact back to the bench? Otherwise paused becomes the handover all by itself.
17分讨论已关闭
此讨论已连续六个月没有活动，现已关闭新回复。 最后活动： .