I cannot use our FR5 monitor total for planning yet. Reconnecting adds the retained plate completion again, even though the saved job register still identifies the same check. The operator did not request another run.
One retained completion adds two plates to our shift figure
HarishAbbott0054 · 2025年7月12日 22:20 UTC
主帖中文翻译暂不可用，以下显示英文原文；回复保留原文。 查看英文原文
3 条回复
Ask the application owner how it matches a completion to the saved job before increasing the total; reconnecting should not invent a second physical plate
4分They found an unconditional increment on the first successful read after reconnect. The retained job reference is available, but that callback did not use it. A bookkeeping revision is being tested.
8分Try an unknown reference too, so the revision has somewhere honest to put a completion it cannot match rather than guessing it into the shift figure
12分讨论已关闭
此讨论已连续六个月没有活动，现已关闭新回复。 最后活动： .