简体中文界面。帖子、指南及政策正文保留原文；未对原文作自动翻译。
HassanBennett0704 · 2026年6月8日 15:32 UTC
Can you link a restrained reading and a released reading to the same bracket, with the measurement supports identified?
9分No paired readings. I have a batch sheet saying aligned and a final inspection sheet with dimensions, but no part numbers connecting them. The support sketch is also absent.
19分Then I would leave the amount of movement unknown; actually, even the word movement assumes those two checks used comparable references.
20分I inherited a teaching fixture with a little packing piece nobody mentioned in the lesson notes, and the technician recognised it immediately when I showed him the old photographs.
-7分Hana, was the packing piece supporting the bracket for measurement or changing how it sat for welding?
20分It supported ours on the inspection bench, which is why the photograph of the welding fixture alone had been no help.
11分I found photographs of our fixture but none of the inspection bench. I have asked the former inspector about that missing setup. The UR5e handover still has a blank there (a deliberate blank now).
18分Who is meant to own that blank, Hassan? I'd want a name before the training date turns it into an operator's problem.
14分