I sat through an FR10 mill-loading presentation where an aluminium blank floated into the pocket with no gripper attached. Asked to see the tool and got told that comes later. The door was missing too. I'd like later to happen before we choose where the base goes.
the doorway gets smaller when we draw the tool
ClaraArcher0350 · 2025年7月5日 22:49 UTC
主帖中文翻译暂不可用，以下显示英文原文；回复保留原文。 查看英文原文
3 条回复
Request a provisional complete tool assembly and the measured open-door position for the comparison. Identify what is still undecided. A fixture point within reach is not enough to approve the loaded approach.
5分Toolmaker sent the assembly. It has a side-mounted fitting right where their invisible gripper used to clear the door. We're comparing another approach now. Funny how much easier this was when half of it wasn't drawn.
7分Check the same assembly on the way out, with the blank held in its intended orientation. Then include the setter's access in the candidate-base review before purchasing treats it as a decision.
16分讨论已关闭
此讨论已连续六个月没有活动，现已关闭新回复。 最后活动： .