I've marked the unsupported ends in our proposed FR10 carton layer, but the packing team has only seen the top view and tooling has only checked finger clearance; I need one review of the filled cartons, including the part-finished layer when an order ends.
turned cartons leave unsupported ends in our fr10 drawing
BrunoChan1061 · 2026年3月10日 07:57 UTC
主帖中文翻译暂不可用，以下显示英文原文；回复保留原文。 查看英文原文
1 条回复
We found the awkward bit on a partial order, after everyone had agreed the repeating pattern; show the supported faces over the actual lower layer, then have packaging and tooling follow the same placement sequence, including where the tool leaves each carton.
25分讨论已关闭
此讨论已连续六个月没有活动，现已关闭新回复。 最后活动： .