I've marked the unsupported ends in our proposed FR10 carton layer, but the packing team has only seen the top view and tooling has only checked finger clearance; I need one review of the filled cartons, including the part-finished layer when an order ends.
turned cartons leave unsupported ends in our fr10 drawing
BrunoChan1061 · 10 Mar 2026, 07:57 UTC
1 reply
Replying to BrunoChan1061
We found the awkward bit on a partial order, after everyone had agreed the repeating pattern; show the supported faces over the actual lower layer, then have packaging and tooling follow the same placement sequence, including where the tool leaves each carton.
25pointsDiscussion closed
This discussion is closed to new replies after six months without activity. Last activity: .