简体中文界面。帖子、指南及政策正文保留原文；未对原文作自动翻译。
Harriet_Campbell · 2026年6月15日 00:40 UTC
Could you get a measured side view before paying for more modelling? The tool needs space with the blank held, not only room to arrive at the fixture.
8分I'd include the actual door stop position in that view. We had a drawing with a door further open than its installed travel allowed.
7分Aaron, was that visible on the machine drawing or did someone have to measure it? We tend to receive the nice outline first.
7分Our outline has no stop detail either, so I have asked the machine supplier for that position and the tool designer for the held-blank envelope
15分Rachel, measured against the installed stop with the machine team. The old drawing wasn't wrong for its revision; it just wasn't our installation.
16分The combined side view is back, and the held blank clears but a fitting on the gripper occupies the door frame on withdrawal
3分That fitting is an expensive omission from a reach circle. Has the tool designer offered another arrangement, or is this still the only one under review?
4分Only this arrangement so far. Thanks Aaron for the door-stop point; the supplier confirmed the installed position before we compared it, so at least that part is no longer guessed
19分Glad that helped. I'd take the clash back to both designers before moving the base on paper. A moved base would need another complete access check.
20分