I've kept the retired correction aid out of our UR5e fixture design. This current-revision history has another gap: its first check is against the clamped stops, then a released failure appears. No comparable free-part reading before welding. I want that distinction kept in the new trial scope
The current bracket check still starts under restraint
NinaAllen0327 · 2025年10月16日 13:08 UTC
主帖中文翻译暂不可用，以下显示英文原文；回复保留原文。 查看英文原文
6 条回复
Name the actual checks and who performs them, rather than putting aligned in two boxes and letting the trainer explain later why they mean different things
14分回复 LuisAli0260
I've separated fit-up contact, released measurement and correction. The released result is an upright-angle failure. Fit-up was only contact at the stops
12分Which drawing revision and measurement support apply to that upright-angle result?
8分Callum's support question belongs in the operator explanation too, because an angle measured while somebody holds the bracket upright can become quite a different check
3分Drawing F. Inspection support reference is missing, so quality is checking it. I'm not using that angle as a measured change from the earlier fit-up contact
2分Who will define the new trial's measurement support if the old one cannot be identified?
11分讨论已关闭
此讨论已连续六个月没有活动，现已关闭新回复。 最后活动： .