简体中文界面。帖子、指南及政策正文保留原文;未对原文作自动翻译。

FR5 layer drawing still leaves the packed box underside out

AnikaChan1117 · 2025年10月13日 10:01 UTC

已关闭
AN
AnikaChan1117
I've received another top view of our FR5 carton pattern. It fits the pallet, but the reinforced box ends sit over gaps in the rotated row. I asked for support and tool access together.

13 条回复

OL
OliverArcher0363

Who is collecting the packaging and tooling comments into one revision? It sounds as though somebody keeps answering the carton-count question you aren't asking.

5
AN
AnikaChan1117

Integrator owns the layout, but packaging's underside sketch wasn't attached to their latest review. I've sent it directly to both designers now.

5
BR
BrunoAli0191

Ask them to show the fingers through release and withdrawal in the section too. A gap that looks sufficient in the finished layer might not leave room to get the tool out.

10
EL
ElliotBaker0509

We got stuck with separate layer views on a UR5e proposal. Overlaying the lower layer made the argument much shorter. Has anyone checked the first layer against your pallet deck as well?

4
HE
HenryBennett0699

Elliot, yes, the bottom layer gets forgotten because everyone is busy arguing about rotation. It still needs the carton bearing areas drawn against the deck.

4
OL
OliverArcher0363

Anika, are short orders common enough that partial pallets need their own agreed arrangement?

4
AN
AnikaChan1117

Yes, Oliver. Packaging has the order mix now. Elliot, deck support is included in the revised request; Bruno, so is complete finger withdrawal.

9
BR
BrunoAli0191

Oliver, do you normally finish partials by hand? I'd want to know where the operator needs to reach before recommending another gap arrangement.

3
OL
OliverArcher0363

In our area, yes, with an agreed manual pattern. I wouldn't assume Anika's proposed automatic sequence could leave the pallet anywhere convenient for that without a separate check.

3
HE
HenryBennett0699

Keep the operator's pallet diagram with the approved revision when you get there. We changed a pattern and nearly trained people to reproduce the previous one.

3
EL
ElliotBaker0509

And keep any lower-count alternative in the price comparison if one is proposed. More pallets can change the labour saving quite a lot, even when the tool gets an easier job.

14
AN
AnikaChan1117

Joint section review is booked. No replacement pattern proposed yet. Henry, the operator diagram is listed as a handover item, not something we'll remember afterwards.

16
OL
OliverArcher0363

Let us know what packaging says about that rotated row. That's the missing answer, even after all these useful drawing additions.

8

讨论已关闭

此讨论已连续六个月没有活动,现已关闭新回复。 最后活动: .