I'm trying to reconstruct our FR10 sleeve pickup edits. Everyone says the tray hasn't changed. Then the setter tells me he takes the tray carrier off for cleaning and puts it back against pencil marks. There are two sets of marks. The grip is visibly skewed now, and the handover just says 'adjusted to suit'. Suit what?
the tray moves when nobody calls it a change
BenAdams0109 · 2025年9月17日 14:40 UTC
主帖中文翻译暂不可用，以下显示英文原文；回复保留原文。 查看英文原文
18 条回复
回复 BenAdams0109
Do you know which marks were used for each program version?
4分No. One set is under the carrier and only shows when it's removed. The setter says he uses the visible set. I can't tell you who drew either one
25分回复 BenAdams0109
Then ask maintenance to check how the carrier is supposed to locate. Pencil marks may be someone's workaround for a missing stop, rather than an intended setting method.
4分Drawing shows a locating strip. There's a strip fitted, but it stops short of one end of the carrier. Maintenance has the drawing and the actual assembly now.
10分回复 BenAdams0109
That's enough to check without buying new fingers. I've seen a tray pulled against one stop at one end and sitting on swarf at the other. Looked lined up from the front. It wasn't.
10分回复 BenAdams0109
And find whoever wrote that handover. They might remember which problem they were chasing even if the note is useless on its own.
14分David, the fingers still deserve a look. Ben said the grip is skewed, not that the carrier has been found skewed.
5分Sure. I said don't buy them, not don't inspect them. I'd check contact faces while maintenance has it accessible.
6分Reece, the last editor remembers the sleeves leaning towards the aisle. No pocket numbers. Maintenance will inspect the fingers as well as the carrier, Henry and David.
20分回复 BenAdams0109
Aisle side on every pickup, or just the one he was watching?
13分回复 BenAdams0109
Compare the retained program versions with the physical changes before selecting a baseline; a correctly refitted carrier may leave those later offsets inappropriate.
14分回复 BenAdams0109
Has maintenance measured the carrier seating yet?
11分They found a packing piece trapped under one end. Fingers match the drawing on their checks. David, the editor only remembers one pickup, so I shouldn't have made his recollection sound like a pattern.
25分回复 BenAdams0109
Who owns refitting that carrier? Cleaning instructions ought to reach the person doing it, not just the robot programmer.
2分Setter owns refitting. He's working with maintenance on a positive seating check. Theo, controls has all three program versions and hasn't picked one just because its filename says original.
6分回复 BenAdams0109
Did the reviewed pickup test run after the carrier work, Ben?
15分回复 TheoAli0236
Yes. The checked setup picked square in the supervised sample trial. We haven't recreated every old complaint. Carrier refitting instructions are being updated; I still want the trial across the other trays before calling the job finished.
12分回复 BenAdams0109
What was the packing piece from? I'd be looking for the matching missing bit before congratulating myself on finding rubbish.
11分讨论已关闭
此讨论已连续六个月没有活动，现已关闭新回复。 最后活动： .