The spacer block is located in the tray but turns as the fingers take it, and I want maintenance comparing the complete fitted contact positions before another pickup correction; we already know looking at a tray from above isn't a locating check
Which fitted contact is turning our UR5e spacer block?
LuisAli0260 · 2026年2月26日 14:13 UTC
主帖中文翻译暂不可用，以下显示英文原文；回复保留原文。 查看英文原文
5 条回复
回复 LuisAli0260
Compare the tray location and the assembled finger contacts with the intended drawings, including backing pieces and wear, using identified blocks rather than whichever sample happens to be nearest.
14分Tray checked correctly; one replacement contact strip stands farther out because it was fitted over an older backing piece, and maintenance has both the assembly drawing and the actual parts now
9分回复 LuisAli0260
Has maintenance restored the intended assembly, with the programmer reviewing the compensating edits against it rather than retaining corrections made for the extra thickness?
11分Assembly restored and the compensation reviewed before the controlled comparison; blocks now leave the tray square, though the receiving release still needs its check
17分回复 LuisAli0260
Correct the replacement instruction as well, so the next strip does not inherit the same backing piece.
10分讨论已关闭
此讨论已连续六个月没有活动，现已关闭新回复。 最后活动： .