I overlaid the filled component-case section on our proposed FR10 layer and found the rotated bearing strips directly above the finger channels; packaging and tooling need to review the same placement sequence before this pattern enters the offer.
Our FR10 tool channels sit beneath the case bearing strips
HassanArcher0356 · 2026年3月31日 11:23 UTC
主帖中文翻译暂不可用，以下显示英文原文；回复保留原文。 查看英文原文
1 条回复
Start with that overlaid section and the tool in its actual carrying, release and withdrawal positions. Ask packaging to mark the support required at each stage. A finished-stack view is too late to show where the case is supported while the fingers leave.
24分讨论已关闭
此讨论已连续六个月没有活动，现已关闭新回复。 最后活动： .