I overlaid the filled component-case section on our proposed FR10 layer and found the rotated bearing strips directly above the finger channels; packaging and tooling need to review the same placement sequence before this pattern enters the offer.
Our FR10 tool channels sit beneath the case bearing strips
HassanArcher0356 · 31 Mar 2026, 11:23 UTC
1 reply
Replying to HassanArcher0356
Start with that overlaid section and the tool in its actual carrying, release and withdrawal positions. Ask packaging to mark the support required at each stage. A finished-stack view is too late to show where the case is supported while the fingers leave.
24pointsDiscussion closed
This discussion is closed to new replies after six months without activity. Last activity: .