From the front, our housing sits flat. Side view shows a gap before the fingers touch. We've been nudging pickup points.
Our FR5 housing only looks seated from the front
PriyaAli0220 · 2025年12月30日 12:27 UTC
主帖中文翻译暂不可用，以下显示英文原文；回复保留原文。 查看英文原文
11 条回复
回复 PriyaAli0220
Retain that housing and tray position for maintenance to compare with the intended support, alongside the fitted fingers, pads and tool mounting; preserve the pickup versions so the mechanical findings can be reviewed against the changes already made.
10分Retained both. The side gap is visible before pickup. No new edit planned.
12分回复 PriyaAli0220
Is it the same gap in every pocket, Priya? I'd have a look at that before anyone buys a set of pads because the grip looks crooked.
3分回复 PriyaAli0220
Can the loader see that side in the actual job? On ours I could see a false seat beautifully from the maintenance side and not at all from where I loaded the tray. Took me an embarrassingly long time to notice why nobody else spotted it.
11分Harish, two pockets show it in retained clips. Theo, that side faces away from the loader.
12分回复 PriyaAli0220
Are those two pockets on one tray or different trays?
7分Theo's viewing point belongs in the eventual setup review, though making the gap easier to see would not explain why the housing is finding that seat in the first place.
7分Same tray, Nadia. Maintenance found damaged support edges in those pockets; replacement arrangement still under review.
11分回复 PriyaAli0220
That gives them something concrete. I'd still compare the held housing after the support work, with those pickup edits reviewed. Otherwise the tray gets corrected and the old compensation stays behind.
15分回复 PriyaAli0220
Any comparison after the support work yet?
6分Not yet. Tray withheld, pickup versions saved. Loader visibility is part of the review too.
2分讨论已关闭
此讨论已连续六个月没有活动，现已关闭新回复。 最后活动： .