PriyaAli0220 · 30 Dec 2025, 12:27 UTC
Retain that housing and tray position for maintenance to compare with the intended support, alongside the fitted fingers, pads and tool mounting; preserve the pickup versions so the mechanical findings can be reviewed against the changes already made.
10 pointsRetained both. The side gap is visible before pickup. No new edit planned.
12 pointsIs it the same gap in every pocket, Priya? I'd have a look at that before anyone buys a set of pads because the grip looks crooked.
3 pointsCan the loader see that side in the actual job? On ours I could see a false seat beautifully from the maintenance side and not at all from where I loaded the tray. Took me an embarrassingly long time to notice why nobody else spotted it.
11 pointsHarish, two pockets show it in retained clips. Theo, that side faces away from the loader.
12 pointsAre those two pockets on one tray or different trays?
7 pointsTheo's viewing point belongs in the eventual setup review, though making the gap easier to see would not explain why the housing is finding that seat in the first place.
7 pointsSame tray, Nadia. Maintenance found damaged support edges in those pockets; replacement arrangement still under review.
11 pointsThat gives them something concrete. I'd still compare the held housing after the support work, with those pickup edits reviewed. Otherwise the tray gets corrected and the old compensation stays behind.
15 pointsAny comparison after the support work yet?
6 pointsNot yet. Tray withheld, pickup versions saved. Loader visibility is part of the review too.
2 pointsThis discussion is closed to new replies after six months without activity. Last activity: .