Our UR5e pallet proposal rotates every second layer. Some carton ends then bridge the gaps below. I need packaging and tooling to check the same layout before we choose it.
Carton support lost between pallet layers
AaronArcher0349 · 2025年6月24日 13:22 UTC
主帖中文翻译暂不可用，以下显示英文原文；回复保留原文。 查看英文原文
10 条回复
Mark the internal supports on the layer drawings. Include the gripper open at release. Otherwise packaging will close the gaps and tooling will quietly put them back.
12分I have the insert drawing now. The load sits on two narrow end sections, not the full carton base.
16分Which insert revision is it? Check that against the filled cartons you intend to use for the review.
15分And where does the operator stand when a carton needs sorting out?
-4分That needs review, but carton recovery is not a reason to leave unsupported ends in the normal pattern.
13分Jane, are you thinking of reaching the far row, because our dispatch team brought that up before anyone mentioned the tool?
18分Yes, the far row; I didn't ask them to keep the bad support, Nathan
13分Insert revision B matches our sample cartons. The proposed recovery access is from one side only. I have added Jane's far-row question to the review.
1分Packaging wants to change the upper row positions. Tooling is checking them now. No pattern accepted yet.
11分Please post the eventual arrangement, Aaron, especially if the access question changes which side the pallet faces.
25分讨论已关闭
此讨论已连续六个月没有活动，现已关闭新回复。 最后活动： .