I want the actual filled carton and its bearing edges on the FR5 support section. The current alternating layout puts a turned end above a gap and calls it supported because the outer rectangle fits. Tooling and packaging need to assess one revision before this reaches the dispatch sheet.
fr5 layer drawing supports the outline, not our carton
LucyChan1089 · 2026年4月9日 22:02 UTC
主帖中文翻译暂不可用，以下显示英文原文；回复保留原文。 查看英文原文
1 条回复
回复 LucyChan1089
Show the gap beneath the required bearing area in a section, with the carton construction identified. Ask tooling to include the finger route during placement and withdrawal as well. I would also include the incomplete layer, since dispatch may stop before the tidy final picture exists.
6分讨论已关闭
此讨论已连续六个月没有活动，现已关闭新回复。 最后活动： .