I want the actual filled carton and its bearing edges on the FR5 support section. The current alternating layout puts a turned end above a gap and calls it supported because the outer rectangle fits. Tooling and packaging need to assess one revision before this reaches the dispatch sheet.
fr5 layer drawing supports the outline, not our carton
LucyChan1089 · 9 Apr 2026, 22:02 UTC
1 reply
Replying to LucyChan1089
Show the gap beneath the required bearing area in a section, with the carton construction identified. Ask tooling to include the finger route during placement and withdrawal as well. I would also include the incomplete layer, since dispatch may stop before the tidy final picture exists.
6pointsDiscussion closed
This discussion is closed to new replies after six months without activity. Last activity: .