Fixture reachable on paper. Gripper body and open door absent. What establishes loading access before an FR10 choice?
FR10 polymer-blank loading sketch without the open door
Simon_Carr · 2026年6月29日 17:04 UTC
主帖中文翻译暂不可用，以下显示英文原文；回复保留原文。 查看英文原文
8 条回复
回复 Simon_Carr
Start with the measured machine opening and parked door around the complete tool carrying the blank, then check the connected entry, release and exit rather than two endpoints; keep the setter's work space in the same layout
21分回复 JoFixtures
Door needs surveying. Tool outline exists, but the held blank position is not defined.
24分回复 Simon_Carr
Have the toolmaker state the intended grip depth before assembling the view, otherwise the carried blank can quietly move inside the fingers every time somebody needs more clearance.
11分Grip position supplied. Door measured. Integrator found the loaded approach clips the parked handle.
7分回复 Simon_Carr
Does a different approach preserve the grip and the process requirements? I'd want that answer before anyone calls it solved by rotating the drawing. The machine lead should also confirm which door arrangement is actually available in use.
13分回复 Simon_Carr
And don't move the handle or change the door arrangement as an unpriced convenience, Simon, any proposed machine change needs its proper owner and review
19分回复 LeahChan1104
No machine change proposed. Toolmaker and integrator are assessing another approach with the same grip.
7分回复 Simon_Carr
That leaves a defined alternative to assess, not an approved route yet. Keep the complete return and the setter's access in its scope; the first conflict disappearing would be useful progress, but not the whole arm-selection decision.
13分