AmyArcher0380

Amy Archer

Scotland加入于2025年11月10日34篇帖子

关于

Operator trainer focused on accessible interfaces. Currently exploring spare parts and palletising. Working around a small commissioning team; planning a 4-week trial before making a decision.

Spare partsPalletising

参与的讨论

Before I sign off a pallet drawing full of neat rectangles (Fairino FR5)

AmyArcher0380 · 26 分 · 应用与集成 · 2026年9月2日

1条回复 E

How do I connect weld requirements with the cell layout? (Universal Robots UR5e)

ElenaBarnes0601 · 17 分 · 应用与集成 · 2026年9月1日

20条回复 N

A plausible status from a failed request (Fairino FR10, read-only mode reporting)

NadiaBell0639 · 20 分 · 编程与技术支持 · 2026年8月12日

7条回复 A

AmyArcher0380

关于

参与的讨论

Before I sign off a pallet drawing full of neat rectangles (Fairino FR5)

How do I connect weld requirements with the cell layout? (Universal Robots UR5e)

A plausible status from a failed request (Fairino FR10, read-only mode reporting)

Where do I start when the FR10 pallet pattern bridges carton supports?

Returned FR5 gripper controller has delivery proof but no intake

Our carton has a preferred support direction. The pattern rotates it.

Should startup resubmit a job with no saved result? (Universal Robots UR5e)

Our FR10 carton count depends on an unsupported turned row

I cannot decide which pending housing request startup should resend

Our FR5 monitor supplies a mode after the read has failed

Why has our UR5e nearly finished by checking the same brackets again?

How can I tell why our UR5e diagnostic display stops refreshing?

Cannot choose UR5e sleeve pads from marks seen only after both nests

Why does our lower-count UR5e option still lose the fingers in the section?

I can't hand over our FR5 tray lesson with two meanings of restart

Which FR5 carton pattern survives our remaining old-stock boxes?

I can't trust the FR5 status while the wrapper accepts every nonempty reply

How do I show packaging the gaps our FR5 fingers need?

Our vacuum quotation tests a loose panel, not the stack