简体中文界面。帖子、指南及政策正文保留原文；未对原文作自动翻译。
Tooling engineer
JoFixtures
Jo
United Kingdom加入于2024年12月1日220篇帖子
关于
Tooling engineer in the workshop project. Thoughtful about locating faces, gripper fingers and what a trial actually proves. Tends to draw the awkward bit before buying anything.
FixturesMachine tending
参与的讨论
I5条回复
4条回复D1条回复O8条回复
9条回复C18条回复E17条回复J15条回复R11条回复
4条回复J21条回复L4条回复V1条回复F2条回复D11条回复D10条回复S8条回复E7条回复L12条回复4条回复
Scrap samples for the first handling demo
UR8 Long welding photo: where does the fixture come out?
Our vacuum report covers sealing; what should cover flexing? - planning single-panel vacuum transfers
Enough reach, incomplete drawing
Microduck is $399. I want one, but what would I actually do with it?
How do I connect fixture location with released dimensions?
Which bracket reading came before the correction on our old route?
The bracket only looks right while our old fixture is holding it
I taught the spacer job but left the recovery decisions with me
FR5, machined blanks: I'd start with jaws. Talk me out of it
A fixture point isn't the whole machine-tending approach
The old laptop still works. What am I missing? (Fairino FR5, controller identity recording)
How should our FR10 dashboard reject the new SDK's failed-read container?
The reach sketch leaves out our machine door and gripper
Buying for handling a small aluminum block, unsure what has been checked (Fairino FR10)
The installed controller cooling filter is here; the spare isn't - loading sample trays
FR10 polymer-blank loading sketch without the open door
fr10 identity read fails while ping sometimes gets through
Does our machine-tending layout actually fit the complete tool? (machine fixture unloading)