I have the filled-carton support requirement this time, but the supplier's section only shows the final stack. The turned row still bridges a gap, and there is no intermediate tool position. I want those views reconciled before the layer count reaches our buying sheet.
The FR5 carton section ends before the fingers withdraw
GabrielBrown0888 · 24 Apr 2026, 17:04 UTC
1 reply
Replying to GabrielBrown0888
Ask the layout owner to show that same carton during placement, release and withdrawal against the lower layer. If support disappears during one of those stages, the finished-stack section is leaving out the condition that matters.
17pointsDiscussion closed
This discussion is closed to new replies after six months without activity. Last activity: .