I'm helping gather inspection requirements for an FR10 bracket-welding proposal. The old sheets show a fit check with the clamps on, then a final pass after an unnamed correction. The proposal has dropped that extra step. I do not know enough about welding to say it can disappear just because the arm is new.
The bracket gets its good result only after leaving the jig
HarishChen1185 · 23 Jun 2025, 13:52 UTC
1 reply
Replying to HarishChen1185
I wouldn't promise that either. Ask the welding lead what happened at that step, and quality whether they have any measurements before it. Even a rough count of how often brackets went there would help you see whether the new layout is missing everyday work.
13pointsDiscussion closed
This discussion is closed to new replies after six months without activity. Last activity: .