Our FR5 sleeve tilts during grip closure. The tray location checks correctly; another pickup edit is being suggested.
Sleeve tilts despite the tray being located
LucyAbbott0045 · 18 Mar 2026, 18:00 UTC
6 replies
Replying to LucyAbbott0045
Check how identified sleeves sit before closure and compare the actual finger contacts with the intended assembly. Have those contacts been changed recently, or is the tilt new with the current sleeve stock?
22pointsReplying to SamBell0681
One finger contact was replaced. Earlier sleeves tilt too. Maintenance is checking the fitted contact.
8pointsReplying to LucyAbbott0045
Give maintenance the replacement identity and the saved point changes together. A replacement history can narrow the search, but the actual fitted geometry still needs comparing before choosing which settings belong with it.
23pointsReplying to SamBell0681
The replacement contact is correct but wasn't fully seated on its mounting. Maintenance has corrected that.
15pointsReplying to LucyAbbott0045
Programmer is reviewing the accumulated edits. Full transfer checks have not happened yet.
20pointsReplying to LucyAbbott0045
What prevented it seating, Lucy? The handover should explain that finding so the next replacement does not start the same series of pickup corrections.
23pointsDiscussion closed
This discussion is closed to new replies after six months without activity. Last activity: .