The FR10 proposal reaches our aluminum blank in the fixture, but the tool body and open machine door are absent from the sketch. I would rather discover an awkward exit in a review than after installation. What should the integrator show before we settle the arm and base position?
Why does our FR10 reach drawing leave the gripper outside the problem?
DanielBarnes0565 · 15 Dec 2025, 05:45 UTC
1 reply
Replying to DanielBarnes0565
Has the integrator shown the complete held-blank tool against the surveyed opening, including finger movement and withdrawal, or is the drawing only the final reachable position?
4pointsDiscussion closed
This discussion is closed to new replies after six months without activity. Last activity: .